Electric Submersible Pumps Specs & manuals ↓
Atlas Copco WEDA D100N —10-in Normal-head Submersible Drainage Pump
A 10-inch electric submersible drainage pump for clean or sand-laden water with small solids. The normal-head configuration uses a 92-hp motor and wear-resistant high-chrome impeller. This profile selects 460-volt three-phase 60-hertz operation with the exact N hydraulic curve.
Estimated equipment rental only. Delivery, taxes and applicable fees quoted separately. Final pricing confirmed with dispatch.
Specifications
Equipment
- Manufacturer
- Atlas Copco
- Model
- WEDA D100N —460 V /3ph /60Hz
Selected 460 V electrical configuration
- Model
- WEDA D100N —normal-head
- Supply
- 460 V,3-phase,60 Hz
- Rated motor output P2
- 92 hp
- Electrical input P1
- 74 kW
- Rated current
- 105 A
- Shaft speed
- 1,750 rpm
- Cable size at460 V
- 1 ×AWG2, DOL
- Standard cable length
- 65 ft
- Insulation /protection
- Class H, VFD-ready /IP68
- Voltage tolerance
- ±5% nominal; maximum2% phase imbalance
- Maximum starts
- 30 per hour
- Starting selection
- Direct-on-line;star-delta alternative uses two AWG2 cables
Hydraulics and dimensions
- Discharge
- 10 in;EN1092-1/BS4504 PN10 DN250 flange
- Hydraulic selection
- Normal-head
- Maximum flow
- Up to4,780 US gal/min;US manufacturer listing
- Head /flow rating
- Use the selected N curve in the original factory60Hz performance sheet
- Strainer-hole solids passage
- 12 mm
- Weight excluding cable
- 1,156 lb
- Height
- 55.6 in
- Width
- 25.6 in
- Diameter
- 23.6 in
Liquid and construction
- Maximum liquid temperature
- 104°F /40°C
- Maximum immersion depth
- 65 ft
- Maximum liquid specific gravity
- 1.1
- Liquid pH
- 5–8
- Casted components
- Corrosion-resistant aluminum
- Impeller
- High-chrome iron;55±5 HRC
- Wear components
- Cast iron and NBR rubber
- Shaft
- Stainless steel
- O-rings
- NBR rubber
- Thermal contacts
- 140°C /284°F
- Mechanical seal
- Primary SiC/WC;secondary carbon/SiC
Equipment Details
Capabilities & Features
- A high-chrome impeller resists wear from abrasive water.
- An oil-bath mechanical seal protects the electrical motor.
- A VFD-ready Class H motor supports compatible speed-control installations.
